Author / Contributor
image for Hiroshi Iino
Hiroshi Iino More Posts
Parent Resource188
Three Teaching Case Studies of Accidents in Nuclear Energy Development in Japan

Added08/15/2006

Updated01/29/2016

Author(s) Hiroshi Iino

Author: Hiroshi Iino

Kanazawa Institute of Technology, Japan

Author: Hiroshi Iino

Kanazawa Institute of Technology, Japan

Read More
Share with EEL Yes
Rights For more information on permissions to use this material please see: http://onlineethics.org/permissions.aspx
Year 2006
Publisher provided Keywords Case Cases chemical Corporate design Discipline: ENGINEERING Essay ethics Government Historical Nuclear professional PUBLIC radioactive RESPONSIBILITY safety Setting: substances teaching Type: University worker
Publisher National Academy of Engineering
Language English

Search this Publication

Case 2: Fire and Explosion at Bituminization Demonstration Facility in 1997

(3)The second accident occurred 14 months after the first one at Tokai Works of PNC, located in Tokaimura, 140km north of Tokyo. The facility mixes a low radioactive nuclear wastewater with molten bitumen and evaporates water in a steam-heated extruder at 180_ and pours the molten mixture into steel drums (180 liters) to cool down, as illustrated in Fig. 4. Since the waste contains a high percentage of sodium nitrate, a strong oxidation reagent, and bitumen and other organic chemicals, the mixture is likely to initiate oxidation reaction by itself at high temperature. Because of the risk, reagents to retard the oxidation reaction were investigated before the process started operation in 1982.

Engineers planned an experiment to reduce a flow rate by 10% then 20%. Operators from subcontractors observed lowering viscosity of the final mixture, an indication of higher temperature but the thermometer at the exit of the extruder was not working well for years. When they saw pillars of flame on the drums being cooled down, they splashed water from sprinklers for one minute just enough to extinguish the fire. They reported to the engineers. No engineer responsible to the operation came to the place before an explosion occurred 10 hours later and a small amount of radioactive materials went out of the building. Several tens of workers had been scheduled to enter the building 40minutes after the explosion. It was very fortunate that there were no casualties. I think ordinary engineers could have foreseen the explosion if they had understood what caused the original fire and time necessary to cool down the oxidation reaction in the 180 liter drums. This case can be used to caution the students against the following mistakes

  1. Incompetent and inexperienced behavior by the engineers (stationed at dirty, difficult, unimportant, and unhealthy working environment),
  2. Careless experimental design,
  3. Negligence in watching and examining the experiment,
  4. Dereliction of the engineers' responsibility of checking and controlling workers' safety and the floor after the fire,
  5. Some engineers become a kind of managers who do not want to know and do not know what is going on the operating floor.
  6. No accident for 15 years made them smug and think the operation is completely safe, although there was a similar accident in Belgium
  7. Delay in informing community agencies about the accident.

6. and 7. are common to the first and second accidents.

PNC in charge of both operations was reorganized into JNC (Japan Nuclear Cycle Development Corp) because of the two accidents and their poor handling of the situations despite their thirty years of substantial technical achievements.

For technical detail in English, refer to N. Sasaki, T. Koyama, E. Omori, A. Maki and T. Yamaniuchi "Study on the Cause of the Fire and Explosion Incident at Bituminization Demonstration Facility at PNC Tokai Works", Spectrum798, Denver, Colorado, U.S.A., September 13-18, 1998

Return to Three Teaching Case Studies of Accidents in Nuclear Energy Development in Japan

Author: Hiroshi Iino

  • Using Case Studies Bibliography

    Added03/26/2010

    Updated09/02/2016

    This bibliography includes examples of different ways instructors have used case studies to introduce ethical topics to their students and resources for finding cases and incorporating them into the classroom.

    Author(s) Kelly Laas
    Year 2016
  • Added06/26/2006

    Updated06/07/2016

    In this essay, Dr. Whitbeck outlines an 'agent-centered' approach to learning ethics. The central aim is to prepare students to act wisely and responsibly when faced with moral problems. She provides a number of examples and cases with descriptions of questions and directions for promoting student participation and stimulating thought and discussion.

    Year 1995
Cite this page: "Case 2: Fire and Explosion at Bituminization Demonstration Facility in 1997" Online Ethics Center for Engineering 12/18/2009 OEC Accessed: Monday, May 20, 2019 <www.onlineethics.org/Resources/japancases/22345.aspx>